SDS Repository

sds

Collection
Berkbile Oil
Description
B101 GUM CUTTER AEROSOL 13 OZ.
Tags
Search Tag
Filename
b101_gum_cutter_liquid_sds_2021.pdf
Source
 
Full Text
SAFETY DATA SHEET 1. PRODUCT AND COMPANY IDENTIFICATION Product Name: 2. HAZARDS IDENTIFICATION CLASSIFICATION Flammable Liquids Skin Corrosion/Irritation Eye Damage/Irritation Carcinogenicity 2 2 2A 2 Aspiration hazard 1 SIGNAL WORD: Danger Hazard Statements Highly flammable liquid and vapor. Toxic if swallowed May be fatal if swallowed and enters airways Causes skin / eye irritation May cause drowsiness or dizziness. Suspected of causing cancer Harmful to aquatic life. Toxic to aquatic life with long lasting effects. Precautionary Statements Keep away from heat/sparks/open flames/hot surfaces ? No smoking Do not spray on an open flame or other ignition source Wash hands thoroughly after handling Do not eat, drink or smoke when using this product Use personal protective equipment as required IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician IF SWALLOWED: Rinse mouth. Do NOT induce vomiting IF IN EYES: Rinse continuously with water for several minutes. Remove contact lenses if present and easy to do ? continue rinsing SDS for: BERKEBILE OIL 2+2 BULK INSTANT GUM CUTTER (B-101-B1, B-101-B5, B101-B55) Page 1 of 5 MANUFACTURED FOR: The Berkebile Oil Company INC. 1216 Red Brant Road Somerset, PA 15501 USA Mailing Address: PO BOX 715 Somerset, PA 15501 EMERGENCY NUMBER: (800) 424-9300 (CHEM TREC) INFO NUMBER: (814) 443-1656 IF exposed or concerned: Get medical advice/attention If skin irritation occurs: Get medical advice/attention If eye irritation persists: Get medical advice/attention Protect from sunlight. Do not expose to temperatures exceeding 50 ?C/122 ?F Dispose of contents/container to comply with all local, state, and federal regulations 3. COMPOSITION/INFORMATION ON INGREDIENTS Chemical Name CAS No. Percent ACETONE 67-64-1 45-65% TOLUENE 108-88-3 1330-20-7 124-38-9 67-56-1 10-30% 5-25% 1-20% 1-20% 1-20% XYLENE, MIXED ISOMERS CARBON DIOXIDE METHANOL ETHYLBENZENE 100-41-4 4. FIRST AID MEASURES INHALATION: Remove to fresh air. Administer oxygen if needed. Apply artificial respiration if breating has stopped. Get medical attention. EYE CONTACT: Wash immediately with large volumes of fresh water for at least 15 minutes. Get medical attention. SKIN CONTACT: Wipe off with a towel. Wash with soap and water. Get medical attention if irritation persists. INGESTION: Not a likely route of exposure. Most important symptoms/effects, acute and delayed: Repeated exposure may cause skin dryness or cracking. May cause drowsiness or dizziness. Indication of immediate medical attention and special treatment needed: None known. 5. FIRE FIGHTING MEASURES Suitable and unsuitable extinguishing media: Foam, Alcohol foam, CO2, Dry chemical, Water fog. Water spray may be ineffective. Specific hazards arising from the chemical: Closed containers may explode from internal pressure build-up when exposed to extreme heat and discharge contents. Liquid content of container will support combustion. Overexposure to decomposition products may cause a health hazard. Symptoms may not be readily apparent. Obtain medical attention. Hazardous decomposition products include carbon dioxide, carbon monoxide, and other toxic fumes Special equipment and precautions for fire-fighters: Water may be used to cool containers to prevent pressure build-up and explosion when exposed to extreme heat. Wear goggles and use self-contained breathing apparatus. If water is used, fog nozzles are preferred. 6. ACCIDENTAL RELEASE MEASURES Personal precautions, protective equipment, and emergency procedures: Avoid breathing vapors. Ventilate area. Remove all sources of ignition. SDS for: Page 2 of 5 Methods and materials for containment and cleaning up: Clean up with absorbent material and place in closed containers for disposal. 7. HANDLING AND STORAGE Precautions for safe handling: Do not puncture or incinerate (burn) cans. Do not stick pins, nails, or any other sharp objects into opening on top of can. Do not spray in eyes. Do not take internally. See product label for additional information. Conditions for safe storage, including any incompatibilities: Store and use in cool, dry, well-ventilated areas. Do not store above 120 F. 8. EXPOSURE CONTROL/PERSONAL PROTECTION Chemical Name / CAS No. OSHA Exposure Limits ACGIH Exposure Limits TLV-TWA 500 ppm (NIC Other Exposure Limits ACETONE PEL-TWA 1000 ppm 67-64-1 200 ppm) TLV-STEL 750 ppm (NIC 500 ppm) TWA: 20 ppm 8 hour TOLUENE 108-88-3 TWA: 200 ppm, 8 HOUR CEIL: 300 ppm PEAK: 500 ppm, 10 minute PEL: 100 ppm XYLENE, MIXED ISOMERS 1330-20-7 TLV: 100 PPM STEL: 150 ppm, 15 minutes CARBON DIOXIDE 124-38-9 5000 ppm TWA, 8 hours 5000 ppm TWA; , 8 hours; 30000 ppm STEL, 15 minutes 5000 ppm NIOSH TWA, 10 hours; 30000 ppm NIOSH STEL, 15 minutes METHANOL 67-56-1 PEL: 200 ppm TWA: 200 ppm; STEL: 250 ppm NIOSH: REL: 200 ppm: STEL: 250 ppm; ETHYLBENZENE 100-41-4 TWA: 100 ppm, 8 hour TWA: 100 ppm, 8 hour STEL: 125 ppm, 8 hour Appropriate engineering controls: Ventilation should be sufficient to prevent inhalation of any vapors. General dilution and/or local exhoust ventilation in volume to keep PEL/TLV of most hazardous ingredient below acceptable limit and lel below stated limit. Individual protection measures: Respiratory protection: None under normal use. Avoid breathing vapors. In restricted areas , use approved chemical/mechanical filters designed to remove a combination or particles and vapor. In confined areas, use an approved air line respirator or hood. Self-contained breathing apparatus is required for vapor concentrations above PEL/TLV limits. Protective gloves: None under normal use. Use solvent-resistant for prolonged or repeated contact. Eye protection: None under normal use. However, use of safety glasses with splash guards or full face shield should be used if indicated. Other protective clothing or equipment: None under normal use. However, use of solvent- resistant aprons or other clothing is recommended. Eye washes and safety showers in the workplace are recommended. SHOWERS IN THE WORKPLACE ARE RECOMMENDED. SDS for: Page 3 of 5 9. PHYSICAL AND CHEMICAL PROPERTIES Appearance: Liquid Odor: Solvent Vapor Pressure: Not determined Vapor Density: Heavier than air Density: 0.826290541 Odor threshold: Not determined pH: Not applicable Melting point: Not determined Solubility: Not determined Flash point: Not determined Flammability: Level 3 Aerosol Freezing point: Not determined Boiling point: 0?C Evaporation rate: Slower than ether Explosive Limits: Not applicable Partition coefficient (n- Not determined octanol/water): Autoignition temperature: Not determined Viscosity: Not determined Decomposition temperature: Not determined 10. STABILITY AND REACTIVITY Reactivity: Not reactive under normal conditions of use. Chemical stability: Stable under normal storage and handling conditions. Possibility of hazardous reactions: None known. Incompatible materials: Acids, Bases, Strong oxidizing agents Hazardous decomposition products: Carbon dioxide, carbon monoxide, smoke, fumes, and other products of incomplete combustion. 11. TOXICOLOGICAL INFORMATION Long-term toxicological studies have not been conducted for this product. 12. ECOLOGICAL INFORMATION Long-term ecological studies have not been conducted for this product. 13. DISPOSAL CONSIDERATIONS Dispose of in accordance with local, state, and federal regulations. Before attempting clean up, refer to other sections of this document for hazard cautionary information. 14. TRANSPORT INFORMATION By land: DOT Proper Shipping Name: UN1992, Flammable Liquids, toxic, n.o.s. (Methanol RQ = 10225 LBS, Toluene RQ = 5348 LBS) By water: DOT & IMDG Proper Shipping Name: UN1992, FLAMMABLE LIQUID, TOXIC, N.O.S. (Methanol, Toluene) Packing group II | Class 3 | Subsidiary risk 6.1 | Label(s) 3, 6.1 By air: DOT & IATA Proper Shipping Name: UN1992, FLAMMABLE LIQUID, TOXIC, N.O.S. (Methanol, Toluene) Packing group II | Class 3 | Subsidiary risk 6.1 | Label(s) 3, 6.1 SDS for: Page 4 of 5 Class 3 Packing group II Subsidiary risk 6.1 Label(s) 3, 6.1 Packaging exceptions 150 Packaging non bulk 202 Packaging bulk 243 SDS for: Page 5 of 5 THE INFORMATION CONTAINED HEREIN IS BASED ON DATA CONSIDEREDACCURATE. HOWEVER, NO WARRANTY IS EXPRESSED OR IMPLIED REGARDING THE ACCURACY OF THE DATA OR THE RESULTS TO BE OBTAINED FROM THE USE THEREOF. BECAUSE THE INFORMATION CONTAINED HEREIN MAY BE APPLIED UNDER CONDITIONS BEYOND OUR CONTROL, WE ASSUME NO RESPONSIBILITY FOR ITS USE. Date Prepared: Date revised: 2021-04-29 Revision 0 16. OTHER INFORMATION All ingredients are either listed on the TSCA inventory or are exempt. 15. REGULATORY INFORMATION