Product Name: AW-1(US) (1/7) SAFETY DATA SHEET MSDS: A4055-130606E31EEN Date Prepared: 2010/07/01 Date Revised: 2013/06/06 1. Identification of the substance/mixture and of the company/undertaking Product Name: Identification of the supplier: Address: AW-1(US) JX Nippon Oil & Energy USA Inc. 20 N. Martingale Rd. Suite 325 Schaumburg, IL 60173 USA Charge section: Lubricants Sales Department 1 (TEL:+1 847-413-2188) 2. Hazards identification hazard category Category Flammable liquids No Classification Acute toxicity(oral) No Classification Acute toxicity(dermal) No Classification Skin corrosion/irritation Specific target organ systemic toxicity following single exposure Specific target organ systemic toxicity following repeated exposure Category 2 No Classification No Classification Aspiration hazard No Classification Acute hazards to the aquatic environment Category 3 Chronic hazards to the aquatic environment Category 3 LABEL ELEMENTS Precautionary pictograms: Signal word: Warning Hazard Statement: Causes skin irritation Harmful to aquatic life Harmful to aquatic life with long lasting effects Precautionary Statements: Prevention Wash hands thoroughly after handling. Do not eat, drink or smoke when using this product. Wear protective gloves/protective clothing/eye protection/face protection. Response Avoid release to the environment. IF ON SKIN: Wash with plenty of soap and water. Take off contaminated clothing and wash before reuse. If skin irritation occurs : Get medical advice/attention. Disposal Dispose of contents/container in accordance with local/regional/national/international regulations. 3. Composition/information on ingredients Substance/Mixture: Mixture 10?4062,?19256039???ACDelco?AW?1?Automatic?Transmission?Fluid? (2/7) SAFETY DATA SHEET MSDS: A4055-130606E31EEN Date Prepared: 2010/07/01 Date Revised: 2013/06/06 Product Name: AW-1(US) ? Ingredients and Concentration Ingredient Name Concentrationwt.% Base Oil(s) 80-90 Additives <20 4. First-aid measures Inhalation: Skin Contact: Eye Contact: Ingestion: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Cover the body with blankets to keep warm and quiet. If you feel unwell, seek medical advice. Immediately flush skin with large amounts of water. Wash contaminated clothing before reuse. If skin irritation occurs : Get medical advice/attention. Rinse with clean water carefully for several minutes. Remove contact lenses if present and if removal is easy, then continue rinsing. Rinse for 15 minutes at a minimum and seek medical attention. Do not induce vomiting. Drink [one glass] [two glasses] of water. Call a physician [or poison control center] immediately. 5. Fire-fighting measures Suitable Extinguishing Media: Extinguishing Media to Avoid: Specific hazards arising from the chemical: Fire Fighting: Special protective equipment and precautions for fire fighters: Mist of loaded liquid, dry chemicals, carbon dioxide, fire foam, and dry sand are effective. Use of straight steam of water can cause a risk of spreading fire. In some cases of fire, may release irritant gases. When burnt, may generate carbon monoxide and other toxic gases. Spray water to the surrounding facilities for cooling. Keep unauthorized persons off the site of occurrence of fire and the surroundings. Even after extinction, cool containers thoroughly with plenty of water. Wear fire/flame resistant/retardant clothing. Fight fire from windward direction while wearing protective equipment. If contact with skin is expected, wear impervious protective equipment and gloves. Use air-breathing apparatus and protective clothing whenever necessary. 6. Accidental release measures Personal precautions, protective equipment and emergency procedures: Wear protective equipment when working. (3/7) SAFETY DATA SHEET MSDS: A4055-130606E31EEN Date Prepared: 2010/07/01 Date Revised: 2013/06/06 Product Name: AW-1(US) ? Environmental precautions: Methods and materials for containment and cleaning up: Prevention of second accident: Remove nearby potential ignition sources immediately. When mist is generated, use respiratory equipment to prevent inhalation of mist. Do not touch or walk through spillage. Pay attention to the site of spillage, which is slippery. Prevent spreading of oil spill with earth and sand, sandbags, or other proper materials and use care not to allow the oil spill to flow to street drains, sewer systems, and rivers. At sea, install oil spill containment booms to prevent spreading of spills and absorb with absorption mat or other proper materials. In case of spillage in small quantity, collect spillage by absorbing with earth, sand, sawdust, waste, or other proper materials. In case of spillage in large quantity, enclose with embankment to prevent spreading of spillage and collect spillage in empty containers to the extent possible. In case of spillage, immediately inform the organizations concerned of the spillage to prevent possible accidents and spreading of spillage. Remove nearby potential ignition sources immediately and make fire-extinguishing agents available. Remove spillage completely, and ventilate and clean the site and the surroundings. 7. Handling and storage Handling Storage Technical Measures: Ventilation requirements: Precautions: Precautions for safe handling: Storage Conditions: Keep away from any possible contact with sparks, open flames, and high-temperature materials, and do not allow release of vapor without justification. Use pumps or other proper equipment for taking out from containers. Do not siphon with your mouth using a tube. Do not drink. When mist is generated, use respiratory equipment to prevent inhalation of mist. In case of vapor/mist dispersion, install a closed system, local ventilation system, and/or other proper equipment for the sources of vapor/mist generation. Avoid rough handling of containers such as falling, dropping, exposing to shock, and dragging. Maintain adequate ventilation when handling indoors. Wash hands and face thoroughly after handling. Be careful with fire. Avoid falling, dropping, exposing to shock, or dragging of containers. Wear protective gloves when opening containers to eliminate a risk of hand injury. Store in a well ventilated, cool, dry, dark place, protecting from direct sunlight and keeping away from any potential ignition sources and high-temperature materials. (4/7) SAFETY DATA SHEET MSDS: A4055-130606E31EEN Date Prepared: 2010/07/01 Date Revised: 2013/06/06 Product Name: AW-1(US) ? Safety adequate container materials: Store tightly stopped after use to prevent possible contamination with dust and moisture. Preferably store locked up in a proper storage area. Use spill-proof containers that are free of damage/corrosion. 8. Exposure controls/personal protection Appropriate engineering controls: In case of mist generation, enclose the source of mist generation, or install a ventilation system. Install eye cleaning and body cleaning equipment near the handling site. Control parameters Ingredient Name Japan Society for Occupational ACGIH Occupational Exposure Limits TLV-STEL TLV-TWA Base Oil(s) None established ppm, 3mg/m3(Mineral Oil Mist) None established ppm, None establishedmg/m3 None established ppm, 5mg/m3(Mineral Oil Mist) Personal Protective Equipment Respiratory Protection: Hand protection: Eye/face protection: Skin Protection: Hygiene Measures: Not needed under normal conditions, but wear a gas mask (against organic gases) whenever required. In case of prolonged or repeated exposure, wear oil-resistant hand protection. In case of exposure to splashes, wear ordinary type goggles. In case of handling over a prolonged period of time or in case of exposure to oil, wear oil-resistant, long-sleeved work clothing. Take off contaminated clothing and wash thoroughly before reuse. Wash hands thoroughly after handling. 9. Physical and chemical properties Product Physical state: Form: Color: Odor: Melting point/freezing point: Initial boiling point and boiling range: Flash point: Auto-ignition temperature: Upper/lower flammability or Liquid Liquid Red Slight odor Pour Point<-42(C) Initial boiling point - End point No data 198(C)Cleveland Open Cup Estimate200-410(C) Explosion Limit (1-7o/) (5/7) SAFETY DATA SHEET MSDS: A4055-130606E31EEN Date Prepared: 2010/07/01 Date Revised: 2013/06/06 Product Name: AW-1(US) ? Vapour density: Density(g/cm3): Solubility: Partition coefficient: n-octanol/water: Decomposition temperature: No data. 0.850 water:Insoluble. No data. No data. 10. Stability and reactivity Chemical stability: Possibility of hazardous reactions: Conditions to avoid: Incompatible materials: Hazardous decomposition products: Stable when stored or preserved in a dark place at room temperature. Keep away from any possible contact with strong oxidizing agents. Contact with incompatible hazard substances Prolonged heating, open flames, and ignition sources Use care to keep away from any possible contact with halogens, strong acids, alkalis, and acidifying substances. When burnt, may release carbon monoxide and other gases. 11. Toxicological information Product Acute toxicity (oral): For mixtures, hazard category was identified based on the classification criteria for mixtures. Acute toxicity (dermal): For mixtures, hazard category was identified based on the classification criteria for mixtures. Acute toxicity (inhalation): For mixtures, hazard category was identified based on the classification criteria for mixtures. Skin corrosion/irritation: For mixtures, hazard category was identified based on the classification criteria for mixtures. Serious eye damage/irritation: For mixtures, hazard category was identified based on the classification criteria for mixtures. Respiratory sensitization: For mixtures, hazard category was identified based on the classification criteria for mixtures. Skin sensitization: For mixtures, hazard category was identified based on the classification criteria for mixtures. Mutagenicity: For mixtures, hazard category was identified based on the classification criteria for mixtures. Carcinogenicity: For mixtures, hazard category was identified based on the classification criteria for mixtures. Reproductive toxicity: For mixtures, hazard category was identified based on the classification criteria for mixtures. Target organ effect/Single exposure: Target organ effect/Multi exposure: For mixtures, hazard category was identified based on the classification criteria for mixtures. For mixtures, hazard category was identified based on the classification criteria for mixtures. Respiratory toxic: For mixtures, hazard category was identified based on the classification criteria for mixtures. Ingredient (6/7) SAFETY DATA SHEET MSDS: A4055-130606E31EEN Date Prepared: 2010/07/01 Date Revised: 2013/06/06 Product Name: AW-1(US) ? Base Oil(s) Acute toxicity (oral): LD50:> 5000 mg/kg[rat] Acute toxicity (dermal): LD50:> 5000 mg/kg[rat] Acute toxicity (inhalation): LC50:> 5 mg/kg[rat] Serious eye damage/irritation: Practically None [rabbit] Skin sensitization: None Buehler method [guinea pig] Mutagenicity: Ames Test:Negative Carcinogenicity: EU:Category 1:R45 need not apply.(NOTE L is Applicable), IARC:3 12. Ecological information Product Ecotoxicity Fish acute toxicity: For mixtures, hazard category was identified based on the classification criteria for mixtures. Algae acute toxicity: For mixtures, hazard category was identified based on the classification criteria for mixtures. Fish chronic toxicity: For mixtures, hazard category was identified based on the classification criteria for mixtures. Algae chronic toxicity: For mixtures, hazard category was identified based on the classification criteria for mixtures. Ingredient Base Oil(s) Ecotoxicity Fish acute toxicity: 96hLC50:> 5000 mg/L[Oncorhynchus mykiss] Daphnia acute toxicity: 48hEC50:> 1000 mg/L[Daphnia magna] 13. Disposal considerations Disposal methods: Dispose of contents/container in accordance with local/regional/national/international regulations. Every customer/user of the product should dispose of industrial waste on its own responsibility, otherwise it must rely on a company authorized by prefectural governor for treating industrial waste or a local public body involved in the disposal of industrial waste for proper disposal. Before disposal of used container, remove contents completely. 14. Transport information IMDG UN classification: Not applicable Specific security precaution and condition of transportation: Transport containers without causing any significant friction or shaking. 15. Regulatory information (7/7) SAFETY DATA SHEET MSDS: A4055-130606E31EEN Date Prepared: 2010/07/01 Date Revised: 2013/06/06 Product Name: AW-1(US) ? Korea(KECL): In the case where one or more components are not listed or, even if listed, in the case of importing to the country or area concerned, an application or notification is required. Australia(AICS): In the case where one or more components are not listed or, even if listed, in the case of importing to the country or area concerned, an application or notification is required. Canada(DSL): All components are listed or exempted. China(IECSC): In the case where one or more components are not listed or, even if listed, in the case of importing to the country or area concerned, an application or notification is required. EU(REACH): In the case where one or more components are not listed or, even if listed, in the case of importing to the country or area concerned, an application or notification is required. New Zealand(NZIoC): In the case where one or more components are not listed or, even if listed, in the case of importing to the country or area concerned, an application or notification is required. USA(TSCA): All components are listed or exempted. Philippines(PICCS): In the case where one or more components are not listed or, even if listed, in the case of importing to the country or area concerned, an application or notification is required. Taiwan: In the case where one or more components are not listed or, even if listed, in the case of importing to the country or area concerned, an application or notification is required. 16. Other information Disclaimer We at JX Nippon Oil & Energy Corporation have prepared the copyrighted Safety Data Sheet to provide reference information on the hazardous chemical product of interest for our customers/users to ensure secure and safe handling. We would like every customer/user of the product to refer to the information and understand the necessity of taking appropriate measures for the actual handling conditions on their own responsibilities for optimum practical application of the product of interest. Consequently, the Safety Data Sheet is not intended to guarantee the safety of the product referenced to herein.