Safety Data Sheet Kem Krest AC Delco Gear Marking Compound Section 1. Identification Product Identifier Kem Krest AC Delco Gear Marking Compound Synonyms N/A Manufacture Stock Numbers N/A Recommended use Refer to Technical Data Uses advised against Refer to Technical Data Manufacturer Contact Address Dynatex Inc. 350 Ring Road Elizabethtown, KY, 42701 USA Phone Emergency Phone Fax (270) 769-3385 (800) 424- 9300 Chemtrec N/A Section 2. Hazards Identification Classification ASPIRATION HAZARD - Category 1 EYE DAMAGE/IRRITATION - Category 2A SKIN CORROSION/IRRITATION - Category 2 Signal Word Danger Pictogram Hazard Statements Causes serious eye irritation Causes skin irritation May be fatal if swallowed and enters airways Precautionary Statements Response Do NOT induce vomiting. If eye irritation persists: Get medical advice/attention. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If on skin: Wash with plenty of water. Page 1 of 7 10-5055, 1052351 - ACDelco Gear Marking Compound Occupational exposure limits, if available, are listed in Section 8. If skin irritation occurs: Get medical advice/attention. If swallowed: Immediately call a poison center or doctor. Specific treatment (see ... on this label) Take off contaminated clothing and wash it before reuse. Prevention Wash thoroughly with soap and water after handling. Wear eye protection/face protection. Wear protective gloves. Storage Store locked up. Disposal Dispose of contents/container in accordance with local, state or federal reglations. Ingredients of unknown toxicity 0% Hazards not Otherwise Classified N/A Section 3. Ingredients CAS Ingredient Name Weight % Proprietary Surfactant 1% - 5% Proprietary Yellow Pigment 30% - 60% Proprietary Lubricating Grease 30% - 60% Section 4. First-aid Measures Inhalation If mist of vapor of this product is inhaled, remove person immediately to fresh air. Seek medical attention if symptoms develop or persist. Skin Contact Immediately wash skin thoroughly with soap and water. If symptoms develop and persist, get medical attention. If this material is injected beneath the skin, regardless of amount injected, get immediate medical attention. Do not wait for symptoms to develop. Eye Contact In case of contact with eyes, rinse with plenty of water and seek medical advice. Ingestion DO NOT INDUCE VOMITING. Seek immediate medical attention. Note This material, if aspirated into the lungs, may cause chemical pneumonitis: treat the affected person appropriately. Page 2 of 7 Section 5. Fire Fighting Measures Suitable Extinguishing Media N/A Unsuitable Extinguishing Media N/A Flammable Limits (LEL and UEL) Not applicable Autoignition Temperature Not applicable Extinguishing Media Carbon Dioxide, Dry Chemical, Foam, Water Fog Special Fire Fighting Procedures Wear self-contained breathing apparatus and full protective equipment. Unusual Fire or Explosion Hazards This product is combustible at high temperatures Hazardous Combustion Products Incomplete combustion can yield low molecular weight hydrocarbons and carbon monoxide. Section 6. Accidental Release Measures Steps to be taken in case of spill or release Prevent further leakage or spillage if safe to do so. Wear appropriate protective equipment and clothing during clean-up. Eliminate ignition sources including sources of electrical, static or frictional sparks. Absorb with inert material. Shovel material into appropriate container for disposal. Local, state and federal laws and regulations may apply to releases and disposal of this material, as well as those materials and items employed in the cleanup of releases. You will need to determine which federal, state and local laws and regulations are applicable. Section 7. Handling and Storage Handling Avoid contact with eyes, skin and clothing. Avoid breathing vapors or mists of this product. Do not take internally. For industrial use only. Provide adequate ventilation. Storage Keep container tightly closed and in a cool, well-ventilated place away from incompatible materials. Do not pressurize, cut, heat or weld containers. Empty product caontainers may contain product residue. Do not reuse empty containers. Page 3 of 7 Section 8. Exposure Controls/Personal Protecction Occupational Exposure Limits Ingredient Name ACGIH TLV OSHA PEL STEL Surfactant N/A N/A N/A Yellow Pigment N/A N/A N/A Lubricating Grease N/A N/A N/A Personal Protective Equipment N/A Engineering Controls Provide local and general exhaust ventilation to effectively remove and prevent buildup of any vapors or mists generated from the handling of this product. Respiratory Protection If ventilation is not sufficient to effectively prevent buildup of aerosols, mists or vapors, appropriate NIOSH/MSHA respiratory protection must be provided. Eye Protection Safety glasses, goggles or face shield to protect against splashing. Skin Protection Chemical resistant, impermeable gloves. Gloves should be tested to determine suitability for prolonged contact. Use of impervious apron and boots is recommended. Page 4 of 7 NoteThe above information is not intended for use in preparing product specifications. Contact Accumetric LLC before writing specifications. Section 9. Physical and Chemical Properties Physical State Liquid Color Yellow Odor Petroleum Odor Threshold N/A Solubility Negligible in water Partition coefficient Water/n- octanol N/A Viscosity N/A Specific Gravity 0.9 Density lbs/Gal N/A Pounds per Cubic Foot N/A Flash Point >300F >148.89C FP Method N/A Ph Not determined Melting Point Not available Boiling Point >300F >148.9C Boiling Range N/A LEL N/A UEL N/A Evaporation Rate Not determined Flammability N/A Decomposition Temperature N/A Auto-ignition Temperature N/A Vapor Pressure Not determined Vapor Density N/A Section 10. Stability and Reactivity Chemical Stability Stable Hazardous Reactions None under normal processing. Hazardous Decomposition Products Carbon dioxide, carbon monoxide and low molecular weight hydrocarbons. Materials to Avoid / Incompatibilities Strong acids, bases and strong oxidizers. Conditions to Avoid Keep away from heat, ignition sources and incompatible materials. Section 11. Toxicological Information No Data Available Page 5 of 7 Section 12. Ecological Information Environmental Fate and Distribution Complete information is not yet available. Environmental Effects Complete information is not yet available. Fate and Effects in Waste Water Treatment Plants Complete information is not yet available. Section 13. Disposal We make no guarantee or warranty of any kind that the use or disposal of this product complies with all local, state, or federal laws. It is also the obligation of each user of the product mentioned herein to determine and comply with the requirements of all applicable statutes. Section 14. Transport Information UN Number N/A UN Proper Shipping Name N/A DOT Classification N/A Packing Group N/A Road/Rail (ADR/RID) Not subject to ADR/RID. Air Shipment (IATA) Not subject to IATA regulations. Road Shipment Information (DOT) Not subject to DOT regulations. Ocean Shipment (IMDG) Not subject to IMDG code. Section 15. Regulatory Information The contents of this MSDS comply with the OSHA Hazard Communication Standard 29 CFR 1910.1200. TSCA Status All chemical substances in this material are included on or exempted from listing on the TSCA Inventory of Chemical Substances. California Proposition 65 This product contains a chemcial know to the State of California to cause cancer. This product contains a chemcial know to the State of California to cause birth defects or other harmful reproductive harm. Page 6 of 7 Section 16. Other Information Revision Date 2/5/2015 Disclaimer The data contained herein is based upon information that Accumetric LLC believes to be reliable. Users of this product have the responsibility to determine that suitability of use and to adopt all necessary precautions to ensure the safety and protection of property and persons involved in said use. All statements or suggestions are made without warranty, expressed or implied, regarding the accuracy of the information, the hazards connected with the use of the material or the results to be obtained from the use thereof. Page 7 of 7