Material Safety Data Sheet Page 1 of 6 Section 1: Product & Company Identification Product Name: New GenerationTM Wheel Bearing Grease Product Number (s): SL3110 Manufactured By: CRC Industries, Inc. General Information (215) 674-4300 885 Louis Drive Technical Assistance (800) 521-3168 Warminster, PA 18974 Customer Service (800) 272-8963 www.crcindustries.com 24-Hr Emergency (CHEMTREC) (800) 424-9300 Section 2: Hazards Identification Emergency Overview Appearance & Odor: Amber semi-solid to solid grease with a faint petroleum odor As defined by OSHA?s Hazard Communication Standard, this product is nonhazardous. Potential Health Effects: EYE: May cause irritation. SKIN: Repeated or prolonged contact can result in drying of the skin. INHALATION: Heating can generate vapors that may cause respiratory irritation, nausea and headaches. Inhalation hazard at room temperature is unlikely due to the low volatility of this product. INGESTION: Can cause stomach ache and vomiting. Main hazard, if ingested, is aspiration into the lungs and subsequent pneumonitis. CHRONIC EFFECTS: Unknown TARGET ORGANS: None known Medical Conditions Aggravated by Exposure: Skin or respiratory conditions See Section 11 for toxicology and carcinogenicity information on product ingredients. Product Name: New GenerationTM Wheel Bearing Grease Product Number (s): Page 2 of 6 Section 3: Composition/Information on Ingredients COMPONENT CAS NUMBER % by Wt. Lubricant base oil blend (highly refined) 64742-52-5 / 64742-65-0 / 64742-53-6 / 64741-96-4 / 64741-88-4 / 64742-01-4 70 - 90 Lithium complex thickener proprietary 7 - 13 Zinc, dithiophosphate di-C1-14-alkyl esters 68649-42-3 0.5 ? 1.5 Antimony dialkyldithiocarbamate proprietary < 0.3 Section 4: First Aid Measures Eye Contact: Immediately flush with plenty of water for 15 minutes. Call a physician if irritation persists. Skin Contact: Remove contaminated clothing and wash affected area with soap and water. Call a physician if irritation persists. Wash contaminated clothing prior to re-use. Inhalation: Remove person to fresh air. Keep person calm. If not breathing, give artificial respiration. If breathing is difficult give oxygen. Call a physician. Ingestion: Do not induce vomiting. Seek medical attention. Note to Physicians: None available Section 5: Fire-Fighting Measures Flammable Properties: This product is nonflammable. Flash Point: 450 F (COC) Upper Explosive Limit: ND Autoignition Temperature: ND Lower Explosive Limit: ND Suitable Extinguishing Media: CO2, dry chemical, sand, dolomite, alcohol resistant foam, water spray Products of Combustion: Oxides of carbon. Sulfur. Phosphorus. Acrid smoke/fumes. Protection of Fire-Fighters: Firefighters should wear self-contained, NIOSH-approved breathing apparatus for protection against suffocation and possible toxic decomposition products. Proper eye and skin protection should be provided. Use water spray to keep fire-exposed containers cool and to knock down vapors which may result from product decomposition. Avoid water in straight hose stream as it will scatter and spread fire. Section 6: Accidental Release Measures Personal Precautions: Use personal protection recommended in Section 8. Minimize skin contact. Environmental Precautions: Take precautions to prevent contamination of ground and surface waters. Do not flush into sewers or storm drains. Advise authorities if product has entered waterways. Product Name: New GenerationTM Wheel Bearing Grease Product Number (s): Page 3 of 6 Methods for Containment & Clean-up: Dike area to contain spill. Ventilate the area with fresh air. If in confined space or limited air circulation area, clean-up workers should wear appropriate respiratory protection. Recover or absorb spilled material using an absorbent designed for chemical spills. Place used absorbents into proper waste containers. Section 7: Handling and Storage Handling Procedures: Keep container away from heat, sparks, and open flame. High temperatures may produce irritating vapors. Eye wash station should be available at work place. Keep containers closed when not in use. Ventilate well, especially in warmer environments. Storage Procedures: Store in a cool dry area out of direct sunlight. Store separated from acids and oxidizing materials. Store away from sparks and open flame. Aerosol Storage Level: NA Section 8: Exposure Controls/Personal Protection Exposure Guidelines: OSHA ACGIH OTHER COMPONENT TWA STEL TWA STEL TWA SOURC E UNIT Lubricant base oil blend 5* NE 5* 10* NE mg/m3 Lithium complex thickener NE NE NE NE NE Zinc, dithiophosphate di-C1-14-alkyl esters NE NE NE NE NE Antimony dialkyldithiocarbamate 0.5 NE 0.5 NE NE mg/m3 N.E. ? Not Established (c) ? ceiling (s) ? skin (v) ? vacated * ? oil mist Engineering Controls: Area should have ventilation to provide fresh air. Use local exhaust to prevent accumulation of vapors. Use mechanical means if necessary to maintain vapor levels below the exposure guidelines. If working in a confined space, follow applicable OSHA regulations Respiratory Protection: None required for normal work where adequate ventilation is provided. Use NIOSH- approved self-contained positive pressure respirators in low circulation areas and for emergencies. Eye/face Protection: For normal conditions, wear safety glasses. Where there is reasonable probability of liquid contact, wear splash-proof goggles. Skin Protection: Use protective gloves such as latex or rubber. Also , use full protective clothing if there is prolonged or repeated contact of liquid with skin. Section 9: Physical and Chemical Properties Physical State: semi-solid grease Color: amber Product Name: New GenerationTM Wheel Bearing Grease Product Number (s): Page 4 of 6 Odor: mild petroleum Specific Gravity: 0.90 @ 60 F Initial Boiling Point: ND Freezing Point: ND Vapor Pressure: < 0.01 mmHg @ 68 F Vapor Density: > 5 (air = 1) Evaporation Rate: < 1 (butyl acetate = 1) Solubility: Insoluble in water pH: NA Volatile Organic Compounds: wt %: 1.0 g/L: 9.0 lbs./gal: 0.075 Section 10: Stability and Reactivity Stability: Stable Conditions to Avoid: None Incompatible Materials: Avoid contact with acids and oxidizing substances. Hazardous Decomposition Products: Oxides of: Carbon. Sulfur. Phosphorus Possibility of Hazardous Reactions: No Section 11: Toxicological Information Long-term toxicological studies have not been conducted for this product. The following information is available for components of this product. ACUTE EFFECTS Component Test Result Route Species Lubricant base oil blend LD50 > 5000 mg/kg Oral Rat Lubricant base oil blend LD50 > 2000 mg/kg Dermal Rabbit CHRONIC EFFECTS Carcinogenicity: Component Result OSHA: None listed IARC: None listed NTP: None listed Mutagenicity: None available Other: Naphthenic distillates Base oils of this product contain < 3% DMSO Extractable total polycyclic aromatic compound (PAC) per IP 346. Section 12: Ecological Information Ecological studies have not been conducted for this product. The following information is available for Product Name: New GenerationTM Wheel Bearing Grease Product Number (s): Page 5 of 6 components of this product. Ecotoxicity: None available Persistence / Degradability: None available Bioaccumulation / Accumulation: None available Mobility in Environment: None available Section 13: Disposal Considerations Disposal: This product is not a RCRA hazardous waste. All disposal activities must comply with federal, state and local regulations. Local regulations may be more stringent than state or national requirements. Section 14: Transport Information Proper shipping description: US DOT (ground): Not Regulated Special Provisions: None Section 15: Regulatory Information U.S. Federal Toxic Substances Control Act (TSCA): All ingredients are either listed on the TSCA inventory or are exempt. Comprehensive Environmental Response, Compensation and Liability Act (CERCLA): Reportable Quantities (RQ?s) exist for the following ingredients: None Spills or releases resulting in the loss of any ingredient at or above its RQ require immediate notification to the National Response Center (800-424-8802) and to your Local Emergency Planning Committee. Superfund Amendments Reauthorization Act (SARA) Title III: Section 302 Extremely Hazardous Substances (EHS): None Section 311/312 Hazard Categories: Fire Hazard No Reactive Hazard No Release of Pressure No Acute Health Hazard No Chronic Health Hazard No Section 313 Toxic Chemicals: This product contains the following substances subject to the reporting requirements of Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 and 40 CFR Part 372: Zinc compounds (< 1.5%), Antimony compounds (< 0.3%) Clean Air Act: Product Name: New GenerationTM Wheel Bearing Grease Product Number (s): Page 6 of 6 Section 112 Hazardous Air Pollutants (HAPs): None State Regulations California Safe Drinking Water and Toxic Enforcement Act (Prop 65): This product may contain the following chemicals known to the state of California to cause cancer, birth defects or other reproductive harm: None State Right to Know: New Jersey: 68649-42-3, 800983-5015P Pennsylvania: 68649-42-3 Massachusetts: None Rhode Island : None Additional Regulatory Information: None Section 16: Other Information NFPA: Health: 1 Flammability: 1 Reactivity: 0 HMIS: Health: 1 Flammability: 1 Reactivity: 0 PPE: B Prepared By: Michelle Rudnick CRC #: 2495 Revision Date: 1/08/2007 Changes since last revision: MSDS reformatted in accordance with ANSI Z400.1-2004 The information contained in this document applies to this specific material as supplied. It may not be valid for this material if it is used in combination with any other materials. This information is accurate to the best of CRC Industries' knowledge or obtained from sources believed by CRC to be accurate. Before using any product, read all warnings and directions on the label. CAS: Chemical Abstract Service NA: Not Applicable ppm: Parts per Million ND: Not Determined TCC: Tag Closed Cup NE: Not Established PMCC: Pensky-Martens Closed Cup g/L: grams per Liter PPE: Personal Protection Equipment lbs./gal: pounds per gallon TWA: Time Weighted Average STEL: Short Term Exposure Limit OSHA: Occupational Safety and Health Administration COC: Cleveland Open Cup ACGIH American Association of Governmental Industrial Hygienists NIOSH National Institute of Occupational Safety & Health mppcf Millions of particles per cubic foot (of air)