Material Safety Data Sheet Date of Preparation: 7/7/00 MSDS No. EFP490 Section 1 ? Chemical Product and Company Identification Product Name: QUEST REFRIGERANT OIL Part Number(s): 490 CAS Number: NOT APPLICABLE TO MIXTURES Product Class: Automotive product Manufacturer: E F Products, Inc. 1860 Crown Drive, Suite 1400, Dallas, TX 75234 Information Phone No.: 1-888-396-0422 Emergency Phone No.: 1-888-396-0422 Section 2 ? Composition/ Information on Ingredients Ingredient Name CAS Number OSHA TWA ACGIH TLV 500 Neutral Refrigerant Oil - - - Section 3 ? Physical and Chemical Properties Physical State: Liquid Boiling Range: Not determined Appearance/Odor: Amber with hydrocarbon odor Vapor Density (Air=1) Heavier than air % Volatile: N/A Specific Gravity (@C20 ?C): 0.9059 Evaporation Rate: N/A Vapor Pressure: 0.01 mm/Hg @ 20C Section 4 ? Fire Fighting Measures Flash Point: 270C Flash Point Method: Open Cup LEL: N/A Extinguishing Media: Water/ Dry chemicals/Foam Unusual Fire or Explosion Hazards: N/A Special Fire-Fighting Procedures: N/A Section 5 ? Stability and Reactivity Stability: Stable Polymerization: Will not occur Incompatibilities & Conditions to Avoid: Strong Oxidizing Agents Hazardous Decomposition Products: Highly unlikely under intended handling and use. Section 6 ? Health Hazard Information Primary Entry Routes: Skin, dermal, inhalation and ingestion Target Organs: Eyes, skin, respiratory system Effects of Overexposure: Can cause eye burns. Prolonged and repeated contact can cause skin irritation. Possibly dermatitis. Carcinogenicity: No components of the product are a carcinogen. Chronic Effects: N/A 07/07/00 MSDS No. 490 Section 6 ? Health Hazard Information Emergency and First Aid Procedures Inhalation: Remove to fresh air. If a cough or other respiratory symptoms develop, consult medical personnel. Eye Contact: Irrigate with eyewash solution or clean water, holding eyelids apart, for at least 10 minutes. If redness, itching or a burning sensation develops, have eyes examined and treated by medical personnel. Skin Contact: Remove contaminated clothing. Wash material off of the skin with plenty of soap and water. If redness, itching, or a burning sensation develops, get medical attention. Wash contaminated clothing and decontaminate footwear before reuse. Ingestion: Do NOT induce vomiting. Wash out mouth with water and give 1 or 2 glasses of water to drink. If gastrointestinal symptoms develop, consult medical personnel. (Never give anything by mouth to an unconscious person). Section 7 ? Spill, Leak, and Disposal Procedures Wear skin protection during clean-up. Contain and absorb large spillages onto an inert, non-flammable absorbent carrier (such as earth or sand). Do not allow to enter drains, sewers or waterways. Shovel into a chemical waste container for disposal or recovery. Section 8 ? Exposure Controls / Personal Protection Ventilation: No OSHA PELs or ACGIH TLVs have been assigned. Minimize exposure in accordance with good industrial hygiene practice. Protective Clothing/Equipment: Wear ISGA standard goggles or face shield. Wear gloves, apron & footwear impervious to this material. Wash clothing before reuse. Safety Stations: Provide eyewash station and safety shower in work area. Use ventilation adequate to maintain safe levels. DOT Transportation Data PART NUMBER(S) SHIPPING NAME HAZARD CLASS IDNO. PACKING GROUP 490 Consumer Commodity ORM-D N/A N/A Disclaimer: All information appearing herein is based upon data obtained from manufacturers and/or recognized technical sources. While the information is believed to be accurate, we make no representations as to its accuracy or sufficiency. Conditions of use are beyond our control, therefore users are responsible for verifying the data under their own operating conditions to determine whether the product is suitable for their particular purposes and they assume all risks of their use, handling, and disposal of the product. Users also assume all risks in regards to the publications of use of, or reliance upon, information contained herein. This information relates only to the product designated herein, and does not relate to its use in combination with any other material or process.