SAFETY DATA SHEET 1. Identification Product identifier Clear Silicone Rubber Other means of identification FIR No. 015016 Recommended use Form-in-place gasket and multi-purpose sealant Recommended restrictions None known. Manufacturer/Importer/Supplier/Distributor information Supplier Company Name Ford Motor Company Address Attention: MSDS Information, P.O. Box 1899 Dearborn, Michigan 48121 USA Telephone 1-800-392-3673 MSDS Information 1-800-448-2063 This email address is being protected from spambots. You need JavaScript enabled to view it. Emergency telephone numbers Poison Control Center: USA and Canada: 1-800-959-3673 INFOTRAC (Transportation): USA and Canada 1-800-535-5053 2. Hazard(s) identification Not classified.Physical hazards Category 2Reproductive toxicity (fertility)Health hazards Not classified.Environmental hazards Not classified.OSHA defined hazards Label elements Signal word Warning Hazard statement Suspected of damaging fertility. Precautionary statement Prevention Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves/protective clothing/eye protection/face protection. Response If exposed or concerned: Get medical advice/attention. Storage Store locked up. Disposal Dispose of contents/container in accordance with local/regional/national/international regulations. Hazard(s) not otherwise classified (HNOC) May irritate eyes and skin. Supplemental information None. 3. Composition/information on ingredients Mixtures CAS number %Chemical name Common name and synonyms 7631-86-9SILICON DIOXIDE 10 - < 20 556-67-2octamethylcyclotetrasiloxane < 1 Specific chemical identity and/or exact percentage (concentration) of composition has been withheld as a trade secret. FIR No.: 015016 SDS US Issue Date: 05-12-2015 Version: 01 1 / 6 4. First-aid measures Inhalation Move to fresh air. Call a physician if symptoms develop or persist. Skin contact Wash off with soap and water. Get medical attention if irritation develops and persists. Eye contact Rinse with water. Get medical attention if irritation develops and persists. Ingestion Rinse mouth. Do not induce vomiting. Get medical attention if symptoms occur. Most important symptoms/effects, acute and delayed Direct contact with eyes may cause temporary irritation. Indication of immediate medical attention and special treatment needed Provide general supportive measures and treat symptomatically. Keep victim under observation. Symptoms may be delayed. General information IF exposed or concerned: Get medical advice/attention. If you feel unwell, seek medical advice (show the label where possible). Ensure that medical personnel are aware of the material(s) involved, and take precautions to protect themselves. Show this safety data sheet to the doctor in attendance. 5. Fire-fighting measures Suitable extinguishing media Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2). Unsuitable extinguishing media Do not use water jet as an extinguisher, as this will spread the fire. Specific hazards arising from the chemical During fire, gases hazardous to health may be formed. Upon decomposition, this product emits carbon monoxide, carbon dioxide and/or low molecular weight hydrocarbons. Special protective equipment and precautions for firefighters Self-contained breathing apparatus and full protective clothing must be worn in case of fire. Fire fighting equipment/instructions Move containers from fire area if you can do so without risk. Specific methods Use standard firefighting procedures and consider the hazards of other involved materials. General fire hazards No unusual fire or explosion hazards noted. 6. Accidental release measures Personal precautions, protective equipment and emergency procedures Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Avoid contact with eyes, skin, and clothing. Wear appropriate protective equipment and clothing during clean-up. Ensure adequate ventilation. Local authorities should be advised if significant spillages cannot be contained. For personal protection, see section 8 of the SDS. Methods and materials for containment and cleaning up Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination. Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS. Environmental precautions Avoid discharge into drains, water courses or onto the ground. 7. Handling and storage Precautions for safe handling Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Avoid contact with eyes, skin, and clothing. Avoid prolonged exposure. Pregnant or breastfeeding women must not handle this product. Should be handled in closed systems, if possible. Provide adequate ventilation. Wear appropriate personal protective equipment. Observe good industrial hygiene practices. Conditions for safe storage, including any incompatibilities Store locked up. Store in original tightly closed container. Store away from incompatible materials (see Section 10 of the SDS). 8. Exposure controls/personal protection Occupational exposure limits US. OSHA Table Z-3 (29 CFR 1910.1000) ValueComponents Type TWA 0.8 mg/m3SILICON DIOXIDE (CAS 7631-86-9) FIR No.: 015016 SDS US Issue Date: 05-12-2015 Version: 01 2 / 6 US. OSHA Table Z-3 (29 CFR 1910.1000) ValueComponents Type 20 mppcf US. NIOSH: Pocket Guide to Chemical Hazards ValueComponents Type TWA 6 mg/m3SILICON DIOXIDE (CAS 7631-86-9) Biological limit values No biological exposure limits noted for the ingredient(s). Appropriate engineering controls Use adequate ventilation to control airborne concentrations below the exposure limits/guidelines. If user operations generate a vapor, dust and/or mist, use process enclosure, local exhaust ventilation, or other engineering controls to control airborne levels below the recommended exposure limits/guidelines. Individual protection measures, such as personal protective equipment Eye/face protection Wear safety glasses with side shields (or goggles). Skin protection Hand protection Suitable chemical protective gloves should be worn when the potential exists for prolonged or repeated skin exposure. The choice of an appropriate glove does not only depend on its material but also on other quality features and is different from one producer to the other. Nitrile gloves are recommended. Neoprene gloves are recommended. Other Wear suitable protective clothing. Wear appropriate chemical resistant clothing if applicable. Respiratory protection If engineering controls do not maintain airborne concentrations to a level which is adequate to protect worker health, an approved respirator must be worn. Respirator selection, use and maintenance should be in accordance with the requirements of OSHA Respiratory Protection Standard 29 CFR 1910.134 and/or Canadian Standard CSA Z94.4. Thermal hazards Wear appropriate thermal protective clothing, when necessary. General hygiene considerations Always observe good personal hygiene measures, such as washing after handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. 9. Physical and chemical properties Appearance Physical state Liquid. Form Paste. Color Colorless. Odor Vinegar-like. Odor threshold Not available. pH Not available. Melting point/freezing point Not available. Initial boiling point and boiling range Not available. Flash point Not available. Evaporation rate Not available. Flammability (solid, gas) Not applicable. Upper/lower flammability or explosive limits Flammability limit - lower (%) Not available. Flammability limit - upper (%) Not available. Explosive limit - lower (%) Not available. Explosive limit - upper (%) Not available. Vapor pressure Not available. Vapor density Not available. FIR No.: 015016 SDS US Issue Date: 05-12-2015 Version: 01 3 / 6 Relative density 1.04 Relative density temperature 77 ?F (25 ?C) Solubility(ies) Solubility (water) Not available. Partition coefficient (n-octanol/water) Not available. Auto-ignition temperature Not available. Decomposition temperature Not available. Viscosity Not available. Other information VOC (Weight %) 3 % CAM310 10. Stability and reactivity Reactivity The product is stable and non-reactive under normal conditions of use, storage and transport. Chemical stability Material is stable under normal conditions. Possibility of hazardous reactions No dangerous reaction known under conditions of normal use. Conditions to avoid Contact with incompatible materials. Incompatible materials Fluorine. Chlorine. Strong oxidizing agents. Hazardous decomposition products Formaldehyde. Upon decomposition, this product emits carbon monoxide, carbon dioxide and/or low molecular weight hydrocarbons. 11. Toxicological information Information on likely routes of exposure Inhalation Prolonged inhalation may be harmful. Skin contact May be irritating to the skin. Eye contact Direct contact with eyes may cause temporary irritation. Ingestion Expected to be a low ingestion hazard. May cause discomfort if swallowed. Symptoms related to the physical, chemical and toxicological characteristics Direct contact with eyes may cause temporary irritation. Information on toxicological effects Acute toxicity Species Calculated/Test ResultsComponents SILICON DIOXIDE (CAS 7631-86-9) LD50 Mouse Oral Acute > 15000 mg/kg Rat > 22500 mg/kg Skin corrosion/irritation Prolonged skin contact may cause temporary irritation. Serious eye damage/eye irritation Direct contact with eyes may cause temporary irritation. Respiratory or skin sensitization Respiratory sensitization Not a respiratory sensitizer. Skin sensitization This product is not expected to cause skin sensitization. Germ cell mutagenicity No data available to indicate product or any components present at greater than 0.1% are mutagenic or genotoxic. Carcinogenicity This product is not considered to be a carcinogen by IARC, ACGIH, NTP, or OSHA. IARC Monographs. Overall Evaluation of Carcinogenicity SILICON DIOXIDE (CAS 7631-86-9) 3 Not classifiable as to carcinogenicity to humans. OSHA Specifically Regulated Substances (29 CFR 1910.1001-1050) Not listed. FIR No.: 015016 SDS US Issue Date: 05-12-2015 Version: 01 4 / 6 Reproductive toxicity Suspected of damaging fertility. Specific target organ toxicity - single exposure Not classified. Specific target organ toxicity - repeated exposure Not classified. Aspiration hazard Not an aspiration hazard. Chronic effects Prolonged inhalation may be harmful. 12. Ecological information Ecotoxicity The product is not classified as environmentally hazardous. However, this does not exclude the possibility that large or frequent spills can have a harmful or damaging effect on the environment. Persistence and degradability No data is available on the degradability of this product. Bioaccumulative potential Mobility in soil No data available. Other adverse effects No other adverse environmental effects (e.g. ozone depletion, photochemical ozone creation potential, endocrine disruption, global warming potential) are expected from this component. 13. Disposal considerations Disposal instructions Collect and reclaim or dispose in sealed containers at licensed waste disposal site. Dispose of contents/container in accordance with local/regional/national/international regulations. Local disposal regulations Dispose in accordance with all applicable regulations. Hazardous waste code The waste code should be assigned in discussion between the user, the producer and the waste disposal company. Waste from residues / unused products Dispose of in accordance with local regulations. Empty containers or liners may retain some product residues. This material and its container must be disposed of in a safe manner (see: Disposal instructions). Contaminated packaging Empty containers should be taken to an approved waste handling site for recycling or disposal. Since emptied containers may retain product residue, follow label warnings even after container is emptied. 14. Transport information DOT Not regulated as dangerous goods. IATA Not regulated as dangerous goods. IMDG Not regulated as dangerous goods. Not established.Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code 15. Regulatory information US federal regulations This product is a "Hazardous Chemical" as defined by the OSHA Hazard Communication Standard, 29 CFR 1910.1200. TSCA Section 12(b) Export Notification (40 CFR 707, Subpt. D) Not regulated. CERCLA Hazardous Substance List (40 CFR 302.4) Not listed. SARA 304 Emergency release notification Not regulated. OSHA Specifically Regulated Substances (29 CFR 1910.1001-1050) Not listed. FIR No.: 015016 SDS US Issue Date: 05-12-2015 Version: 01 5 / 6 Superfund Amendments and Reauthorization Act of 1986 (SARA) Hazard categories Immediate Hazard - Yes Delayed Hazard - Yes Fire Hazard - No Pressure Hazard - No Reactivity Hazard - No SARA 302 Extremely hazardous substance Not listed. SARA 311/312 Hazardous chemical No SARA 313 (TRI reporting) Not regulated. Other federal regulations Clean Air Act (CAA) Section 112 Hazardous Air Pollutants (HAPs) List Not regulated. Clean Air Act (CAA) Section 112(r) Accidental Release Prevention (40 CFR 68.130) Not regulated. Safe Drinking Water Act (SDWA) Not regulated. US state regulations US. California Controlled Substances. CA Department of Justice (California Health and Safety Code Section 11100) Not listed. US. Massachusetts RTK - Substance List SILICON DIOXIDE (CAS 7631-86-9) US. New Jersey Worker and Community Right-to-Know Act SILICON DIOXIDE (CAS 7631-86-9) US. Pennsylvania Worker and Community Right-to-Know Law SILICON DIOXIDE (CAS 7631-86-9) US. Rhode Island RTK Not regulated. US. California Proposition 65 California Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition 65): This material is not known to contain any chemicals currently listed as carcinogens or reproductive toxins. International Inventories All components are listed or are exempt from listing on the Toxic Substances Control Act Inventory. 16. Other information, including date of preparation or last revision Issue date 05-12-2015 Version # 01 HMIS? ratings Health: 2 Flammability: 0 Physical hazard: 0 NFPA ratings Health: 1 Flammability: 1 Instability: 0 Preparation Information and Disclaimer This document was prepared by FCSD-Toxicology, Ford Motor Company, Diagnostic Service Center II, 1800 Fairlane Drive, Allen Park, MI 48101, USA, based in part on information provided by the manufacturer. The information on this data sheet represents our current data and is accurate to the best of our knowledge as to the proper handling of this product under normal conditions and in accordance with the application specified on the packaging and/or technical guidance literature. Any other use of the product which involves using the product in combination with any other product or any other process is the responsibility of the user. To the extent that there are any differences between this product?s Safety Data Sheet (SDS) and the consumer packaged product labels, the SDS should be followed. Part number(s) TA-32 FIR No.: 015016 SDS US Issue Date: 05-12-2015 Version: 01 6 / 6